Manual.ly Logo

JBL Aquaristic ProFlora m2003 Bruksanvisning

0,0 · 0 Betyg

PDF-manual · 163 Sidor

Svenska

M: GO-GEM-FL-25
sida

/ 163

Loading...
d99b7fc22368adb896816115311ea8ac1a02 page 18
22
UK
Please ensure that only those pH values are set which do not harm sh. This is the section of
the table labelled “CO
2
correct“.
12.3 Setting the amount of CO
2
The amount of CO
2
which must be added for the desired pH value depends on various factors
such as water movement, consumption by plants, etc. and must be calculated individually for
each particular aquarium.
• Begin with about 15 bubbles per minute in the JBL Taifun per 100 l aquarium water (this
corresponds to about 10 bubbles per minute using the bubble counter).
• After one day, check whether the desired pH value has been attained in the aquarium.
• Should this not be the case, increase the CO
2
supply to about 20 – 25 bubbles in the JBL
Taifun (approx. 14 - 16 bubbles in the bubble counter). If necessary, increase the supply in
further small stages until the required pH level is reached.
• Check to make sure the pH level is maintained, so that the CO
2
level in the CO
2
permanent
test is also correct.
• In the case of the m503 and m2003 CO
2
kits, the pH computer automatically maintains the
selected pH level.
13 Note on the pressure indicated on the pressure regulator
The CO
2
gas in the CO
2
storage bottles is under high pressure. This pressure depends on the
ambient temperature. At room temperature (approx. 20°C), the left-hand pressure gauge of the
pressure regulator indicates a pressure of about 50 bar. This increases if the room temperature
rises. At 30 °C, the gauge therefore indicates about 70 bar. The pressure in the storage bottle
does not indicate the amount of gas it contains. It remains constant and in line with the sur-
rounding temperature until shortly before the bottle is empty. The amount of CO
2
in a bottle can
only be estimated by weighing. The empty weight (tare) of the storage bottle is stamped on the
bottle. The current weight minus the tare weight equals the amount of CO
2
.
The pressure in the bottle is adjusted downwards by the pressure regulator to an easily man-
ageable pressure, known as the “operating pressure “. The right-hand pressure gauge of the
pressure regulator indicates the operating pressure. In the JBL u001 and m001 pressure regu-
lators, it is preset to approx. 1.5 bar. This is the optimum pressure for CO
2
fertilization of aquari-
ums. If required, however, the operating pressure can also be adjusted using the setting screw,
which is situated under the small black cover at the “nose” of the regulator. When adjusting the
operating pressure, it is important for CO
2
to be released i.e. the adjusting screw should not be
closed, as this would prevent adjustment of the new operating pressure.
14 Changing bottles
If the bottle pressure (left-hand pressure gauge) falls below 30 bar, the bottle will need to be
relled (rellable bottle) within the next 2 – 3 days. The disposable bottle may only be replaced,
when it no longer contains any CO
2
. This is the case, when both pressure gauges indicate 0 and
no CO
2
bubbles rise in the aquarium.
Disposable storage bottles:
Make sure that the disposable bottle is completely empty. No CO
2
bubbles should rise in the
diffuser. Disconnect the CO
2
hose from the pressure regulator and unscrew the pressure regula-
tor from the bottle by turning anti-clockwise. Dispose of the empty bottle according to the local
regulations for waste disposal. Connect a new bottle as described in chapter 11.1.
Rellable storage bottles:
Close the bottle valve and disconnect the CO
2
hose from the pressure regulator. Open the
adjusting screw and release any pressure remaining in the pressure regulator until both pres-
sure gauges indicate 0. Disconnect the connecting nut of the pressure regulator from the bottle
valve. Have the rellable bottle relled.
If no full rellable storage bottles are available at the moment, a disposable bottle can be used.
Using an Allen key (size 6), remove the bottle connection nut from the pressure regulator. The

Chatta med din JBL Aquaristic ProFlora m2003-manual med hjälp av AI

Få omedelbara AI-svar från din JBL Aquaristic ProFlora m2003-manual

Fråga vad som helst om JBL Aquaristic ProFlora m2003. Svaren kommer från denna bruksanvisning, med de sidor de bygger på.

ProFlora m2003 Underhallsschema

Paminn mig nar underhall ska utforas
Varje 2-3:e dag
Kontrollera flasktryck och fyll på

Om flasktrycket sjunker under 30 bar, fyll på den återanvändbara flaskan inom de närmaste 2 till 3 dagarna. Byt ut engångsflaskor endast när de är tomma.

Visa i manualen (sida 24)
Månadsvis
Verifiera pH- och CO2-nivåer

Kontrollera efter en dag om önskad pH har uppnåtts. Övervaka pH-underhåll och CO2-nivåer med en permanent test regelbundet.

Visa i manualen (sida 24)
Efter varje 100 liter
Ställ in initial CO2-dosering

Börja med cirka 15 bubblor per minut i reaktorn per 100 liter akvarievatten (ca 10 bubblor på räknaren).

Visa i manualen (sida 24)

Kostnadsfria underhallspaminnelser

Anpassat efter ditt inkopsdatum. Alltid kostnadsfritt, avsluta prenumerationen nar som helst.

Genom att skicka in godkanner du integritetspolicyn. Avsluta prenumerationen med ett klick i valfritt e-postmeddelande.
M: QW-35-FL

Ställ en Fråga

0/1000

Rekommenderar du ProFlora m2003?

Ja Nej

Vanliga frågor

A

Det är ett CO2-gödslingssystem för växtakvarier, utformat för att stödja frisk växttillväxt och stabila vattenförhållanden i stora akvarier upp till 1000 liter.

Är detta svar till hjälp?

A

Det kan användas av nybörjare, men det är mer avancerat än ett enkelt CO2-kit. Den automatiska pH-styrningen hjälper, men installation, kalibrering och säker hantering kräver fortfarande uppmärksamhet.

Är detta svar till hjälp?

A

Nej. Systemet säljs utan pH-sensor, och en ny JBL pH-sensor måste köpas separat för att pH-styrfunktionen ska fungera tillförlitligt.

Är detta svar till hjälp?

A

Den modulära reaktorn gör det möjligt att anpassa CO2-diffusionen efter akvariets storlek. För m2003 hjälper den utökade konfigurationen till att hantera mycket stora volymer effektivt.

Är detta svar till hjälp?

A

En påfyllningsbar flaska bör fyllas på när trycket sjunker under cirka 30 bar. En engångsflaska byts endast när den är helt tom och inga bubblor finns kvar.

Är detta svar till hjälp?

A

Guiden rekommenderar cirka 15 till 35 mg/l, där 20 till 25 mg/l anses vara idealiskt. Det exakta målet bör anpassas till KH och pH för fiskarnas säkerhet.

Är detta svar till hjälp?

M: GO-GEM-FL-25

Fördelar och Nackdelar

Fördelar

  • Byggd för mycket stora akvarier, med täckning upp till 1000 liter.
  • Modulär reaktordesign hjälper till att anpassa CO2-utmatningen efter akvariets storlek.
  • Automatisk pH-styrning kan stabilisera CO2-doseringen med mindre manuellt arbete.
  • Bubbelräknare och skydd mot bakflöde förbättrar säkerhet och övervakning.
  • Påfyllningsbar CO2-flaska ger en mer resurseffektiv lösning.
VS

Nackdelar

  • Installationen är mer komplex än för ett grundläggande CO2-kit.
  • Initial kalibrering och finjustering kan ta tid.
  • System med påfyllningsbar flaska kräver regelbunden påfyllning och hantering.
  • pH-sensorn ingår inte och måste köpas separat.
M: GO-GEM-FL-25

Produkt Specifikation

Typ

CO2-gödslingssystem

M: GO-GEM-FL-25

Produkt Beskrivning

JBL ProFlora m2003, upp till 1000 l Manual

JBL ProFlora m2003 är en CO2-lösning i premiumklass, utformad för stora akvarier och med stabil växtnäring samt en hälsosammare balans för både fiskar och växter. Systemet är byggt för akvarier upp till 1000 liter och kombinerar en kraftfull 2 kg påfyllningsbar CO2-flaska med en precisions-tryckregulator, en modulär Taifun-reaktor, en bubbelräknare och ett smart pH-styrsystem. I praktiken innebär det jämnare CO2-tillförsel, bättre växttillväxt och enklare kontroll över vattenkemin.

Det som gör JBL ProFlora m2003 speciell är fokus på noggrannhet och bekvämlighet. Tryckregulatorn är konstruerad för finjustering, medan den modulära reaktorn kan byggas ut för att passa akvariets storlek. Detta är särskilt användbart i växtakvarier där CO2-behovet förändras med belysning, växtmassa och vattenrörelse. För akvarister som vill ha en renare installation undviker systemet behovet av en separat vattenpump och förlitar sig i stället på effektiv passiv diffusion.

Den integrerade pH-styrenheten ger ytterligare trygghet. Den mäter pH och temperatur och justerar sedan automatiskt CO2-utmatningen för att hålla förhållandena inom ett säkert och effektivt intervall. Det gör systemet särskilt attraktivt för aquascaping eller krävande växtakvarier, där små förändringar kan få stor effekt. Bubbelräknaren med inbyggt skydd mot bakflöde hjälper också till att skydda regulatorn och flaskan från att vatten tränger in.

En annan fördel är plattformens flexibilitet. Samma familj inkluderar versioner med engångsflaska och påfyllningsbar flaska, valfri nattavstängning samt en glasdiffusorvariant för mindre system. För m2003 gör den större flaskan och den utökade reaktorkapaciteten den lämplig för seriösa växtakvarier som behöver stark och pålitlig prestanda över tid. Resultatet är en välbyggd CO2-lösning som balanserar prestanda, säkerhet och resurseffektivitet.

Noteringar

  • Bäst lämpad för stora växtakvarier och aquascaping.
  • CO2-nivåer bör anpassas till KH och pH för fiskarnas säkerhet.
  • Reaktorn behöver en kort inkörningsperiod innan den når maximal prestanda.
  • Hantering av påfyllningsbar flaska ska alltid ske enligt säkerhetsreglerna.
M: GO-GEM-FL-25

© Copyright 2026 Manual.ly